Site Map
This page makes use of style sheets to control page presentation, in compliance with the World Wide Web consortium's standards. If you are seeing this message, the style sheets are not available either because of an error or because you are using a browser that is not standards-compliant (possibly Netscape 4). The information on this Web site will still be accessible to you.

Scisense Inc. Logo
Pressure Control Units

Pressure Control Unit - FP891B
FP891B

The Scisense FP891B pressure control unit is a single-input signal conditioner and amplifier for use with our solid-state pressure sensors. The FP891B has a sensitivity of 2.2 V/100 mmHg (or 0.022V/mmHg) eliminating the need for any additional amplifiers or signal conditioners. Calibration and zero balance controls are conveniently. located on a 15 degree angle for easy user access.

Dual Pressure Control Unit - FP895B
FP895B

The Scisense FP895B dual pressure-control unit can be used with either 2 single sensor pressure catheters recording simultaneously or with a dual-pressure sensor catheter. The sensitivity for each input is 2.2V/100 mmHg (or 0.022V/mmHg) eliminating the need for any additional amplifiers or signal conditioners. Calibration and zero balance controls are conveniently located on a 15 degree angle for easy user access.
Specifications:

Number of Inputs: FP891B = 1 (9 pin Redel); FP895B = 2 (9 pin Redel)
Pressure Output: 2.3 Volt/100 mmHg
Power Supply Out: +5VDC, +/- 12 VDC
Power Supply In: 100-250 Vac, 50-60 Hz
Dimensions: FP891B
H : 6.6 cm (2.6")
W : 11.7 cm (4.6")
L : 15.4 cm (6.0")		 FP895B
H : 6.9 cm (2.7")
W : 22.6 cm (8.9")
L : 16.8 cm (6.6")
Calibration Controls: 0 mmHg (-2.86V) and 100 mmHg (-0.57V)
Catheter Cable: 122 cm (48”) cable
Output Connector: BNC
Signal Gain: 1143

Ordering Information:

All Pressure Control Units require a cable pack, as follows:

  • FP891B requires cable package FC-SP-PK, which includes: AULT Power Supply (FS-AULT301), Power Cord, (1) Scisense Catheter Cable (FC-1394-4), and (1) BNC-BNC Cable (FC-BNC-6)
  • FP895B requires cable package FC-DP-PK, which includes: AULT Power Supply (FS-AULT301), Power Cord, (2) Scisense Catheter Cables (FC-1394-4), and (2) BNC-BNC Cable (FC-BNC-6)

Top